You do not have any products in your shopping cart yet.
in stock, 1 to 3 days
The SPIN Pro line offers, in comparison with the predecessors,
increased adjustment possibilities, such as automatic motor timing,
shut-off voltage adjustments practicable directly in volts, tuning
of start-up properties for different motor types, as well as new
possibilities of mode activation for setting up autorotation of
Opto controllers have galvanically separated input (the receiver
signal) from power accumulators, therefore it's necessary to use
independent power supply for the receiver and servos (4-5 NiXX or
2-3 LiXX with linear voltage regulator, such as MAX BEC).
SPIN opto controllers are provided with two JR connectors.
Connector on the longer three-line cable with black ending is to be
linked to the receiver. Connector on the shorter three-line cable
with red ending is intended for communication with JETIBOX; for
programming or data reading connect it into slot marked imp. + - on
Servoverlängerungskabel 100cm (System JR) 3x0,32mm² verdrillt Silikon mit Sicherungsclip
Alu Doppel-Servoarm rot 76 mm passend für Futaba Servos
Flächenschutztasche für Yak 55M 1.8 von GB-Models
Z-POXY, 5min Epoxy, 237m
ZAP CA Sekundenkleber, dünnflüssig, Inhalt: 28,3g
AXI Antriebsset zur GB-Models Musger MG 19 für 5s LiPo 359,00 EUR
HEPF Modellbau © 2019 | Template © 2009-2019 by Hepf Modellbau