You do not have any products in your shopping cart yet.
in stock, 1 to 3 days
Linear regulator MAX BEC is a sophisticated tool for regulating
voltage in models which have a receiver and servos powered by 2
LiXX cells or 5-6 NiXX cells. Servo voltage is constant during the
entire flight which results in smooth motion of the servos.
Required output voltage (5.0V, 5.4V, 5.7V, 6.0V) is selected by a
MAX BEC can be supplied either by NiXX or LiXX cells, recommended
are 2 LiXX cells or 5-6 NiXX cells. Input voltage is indicated by
four LED´s. If the input voltage is above 7.0V, all three green
LED´s are ON. While the cells are gradually discharging, particular
LED´s go OFF depending on input voltage (lower then 7V, 6.7V,
6.45V). If the input voltage is under 6.5V, the red LED goes ON
indicating that cells are discharged (if using 2S LiXX then it
means that voltage of particular cells is under 3.25V).
Supply cells must be connected into input side with two 0.5 mm2
cables. There is also parallel-connected 3link with JR connector
which is intended for cells charging, without a need for
disconnection of power connectors. Maximum charging current is 0,5A
(limited by connector).
Output voltage is extracted from output side with 2 links. It is
recommended to connect both 2-links, it results in higher
reliability and lower current loading on connectors. The connectors
may be plugged in any channel of the receiver.
On the output side, there is a switch extracted, which activates
the regulator. The switch is connected as “safe”; it means that
mechanical damage of joints or wires has no impact on BEC
JETI Empfänger Duplex 2.4EX Rex12 Assist ohne Sperrtopf mit 20cm Antenne
Jeti Hand-Sender DS-12 Multimode schwarz
Jeti Hand-Sender DS-12 Multimode rot
XT90 Ladekabel 30cm 14 AWG
Aeronaut Klappluftschraubenblätter 15x8"
D-Power BULLISH Speedliner - 185 cm Elektrosegler ARF+ 399,00 EUR
HEPF Modellbau © 2019 | Template © 2009-2019 by Hepf Modellbau