You do not have any products in your shopping cart yet.
The switching voltage regulator SBEC is supposed to function as
a current supply for receivers and servos. It enables to use a wide
range of input voltages from 3S up to 10S Li-XX cells. Setup of the
output voltage between 5 and 8V is accomplished by a shorting plug
jumper. This implies that the SBEC is also prepared for use with
new „higher“ voltage servos. The SBEC is suitable for medium and
larger model due to its maximum current of 40A.
The output voltage is adjusted with the aid of a shorting plug
(jumper) in steps of 5.0V, 5.5V, 6.0V, 7.0V and 8.0V. An
important condition of keeping correct output voltage in connection
with the jumper position is a sufficiently high supply voltage. The
supply voltage of the battery must by all means be higher than the
required output voltage. We recommend a minimum difference of at
least 2V above the output voltage. Otherwise the output voltage
would decrease under load conditions. The switched-on condition of
the regulator and the information about the presence of voltage at
its output are signaled by a shining green LED.
Jeti Duplex 2.4EX Rex6
Jeti Duplex 2.4EX R14 2,4GHz
Jeti Duplex 2.4EX R11EPC
Jeti Duplex 2.4EX Rex10
FlightLine Focke-Wulf Ta 152H Hauptfahrwerk - rechts 24,00 EUR
HEPF Modellbau © 2019 | Template © 2009-2019 by Hepf Modellbau